Manon Desaulniers Door Knob May 18th, 2018 - 08:55:57
As time went on styles of knobs came and went and it was only in more modern times that the door knobs we used seemed to become a bit more boring and just looked at as things that are meant to open a door. Its possible the boring state of todays door knobs is what caused many hardware manufacturers to go back in time and start lines of pieces that are reproductions of those fascinating antique door knobs. Those reproductions have become a major income for those companies as people continually look for new ways to dress up their home.
If the door opens outwards the flat side should look outwards too if it opens to the inside the flat side should look inwards. Now slip in the cylinder through the door knob hole while holding the opening and closing mechanism pushed in so that it fits into the space provided for it in the door knob cylinder. Find the two large screws and the metal cover that go on the inside and screw it in place. Make sure it is tight but not overly tight. Test this by tuning the outside knob the opening and closing mechanism should retract without resistance.
Now put the screws on the opening and closing mechanisms again do not over tighten them test the door knob again there should be no interference or resistance. The operative mechanism is in place now it is time to finish the decorative part of the installation. Take the decorative plate that covers the mechanism and slip into place until it locks. Before putting in the decorative door knob lock the door and try the key without actually closing the door. The door should lock and unlock without major pressure or resistance.
Look at the base of the knob close to the door itself and you will see a small hole with a little separation inside of it. Take a key like piece of metal that is included in the new doorknob set and put it in the small hole prying it open. Pull the door knob out as you pry the hole until it comes out completely. You will have removed the decorative part of the mechanism and the operative part will be exposed. Against the door itself you will see a round piece of metal which is held in place by two large screws remove these screws all the way.