Paige Migneault Door Knob May 20th, 2018 - 10:36:15
As time went on styles of knobs came and went and it was only in more modern times that the door knobs we used seemed to become a bit more boring and just looked at as things that are meant to open a door. Its possible the boring state of todays door knobs is what caused many hardware manufacturers to go back in time and start lines of pieces that are reproductions of those fascinating antique door knobs. Those reproductions have become a major income for those companies as people continually look for new ways to dress up their home.
The kind of door knob you need depends on whether or not they are an exterior door or an interior door. Exterior door knobs will certainly be required to have a good lock on the door and are required to be weather resistant and a more heavy duty kind door knob than an interior knob set. Any time you replace the outside door knob you are going to have a deadbolt latch which should be replaced at the same time so that you can have matching keys for each of the locks. Interior doors have a practical door knob and are available in two standard general sizes; 2-3/8 inches and also 2-3/4 in.
Moreover the constant touch of sweaty or wet hands on these door knobs can make them look drab. Antique glass door knobs are durable and are prone to different weather conditions. Glass knobs add a flair to the door and make them look aesthetically beautiful. The only way you can get yourself one of these valuable beauties is by constantly keeping a check in antique shops or glass shops that stock vintage products. Since antique glass knobs are in demand there could be instances where individuals end up buying a replica thinking its an antique.
Now take out the strike plate on the door facing by simply removing the 2 anchoring screws which have been retaining it in position. Now you are all set to begin your installation; in the event you purchased an adjustable door knob be sure it is arranged on the correct position. Youve got to install the latch to start off; put it through the small hole confirming it doesnt bind up and screw it firmly into place. Simply somewhat snug the anchoring screws this can let you shift it around slightly to allow the knob assembly to operate a bit more smoothly youll be able to tighten all of them later.