Paige Migneault Door Knob May 02nd, 2018 - 10:48:26
Now take out the strike plate on the door facing by simply removing the 2 anchoring screws which have been retaining it in position. Now you are all set to begin your installation; in the event you purchased an adjustable door knob be sure it is arranged on the correct position. Youve got to install the latch to start off; put it through the small hole confirming it doesnt bind up and screw it firmly into place. Simply somewhat snug the anchoring screws this can let you shift it around slightly to allow the knob assembly to operate a bit more smoothly youll be able to tighten all of them later.
If the door opens outwards the flat side should look outwards too if it opens to the inside the flat side should look inwards. Now slip in the cylinder through the door knob hole while holding the opening and closing mechanism pushed in so that it fits into the space provided for it in the door knob cylinder. Find the two large screws and the metal cover that go on the inside and screw it in place. Make sure it is tight but not overly tight. Test this by tuning the outside knob the opening and closing mechanism should retract without resistance.
As I said before they will last forever and you will never regret it! I my self just cant get enough of them. I believe that they will never be outdated and I always do my best to find the perfect ones for all the furniture in my house. Glass gives that royal feeling to anything that it is attached to and I think that this is the feeling every house should have. Make sure though to take enough time to find those that suit your furniture and environment best as you can always go wrong with the vast amount of choices out there.
Once done you will now see the inside of the wooden door and the part of the doorknob that goes through it. Push the opening and closing mechanism on the front of the door and at the same time pull the remaining piece of the door knob from the outside it will slide out easily leaving a hole that goes through the door. Once this is done take the opening and closing mechanism and slide it out the front of the door too. Now you have to reverse the process place the opening and closing mechanism through the front of the door make sure the flat side of the mechanism looks to the side to which the door opens.